Straight answers and careful work on metal roof repair in Pollocksville, NC. Metal roofing is our specialty, but we do the whole roof.
Metal roofs are our specialty, so repairing one on a Pollocksville home is familiar ground. Backed out screws, split neoprene washers, rust starting at a lap, a panel lifted at the eave — all of it is fixable without replacing the roof.
Roofing Brothers has been doing metal roof repair since 2002, first around Morganton, North Carolina and now for Pollocksville homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof repair starts in Pollocksville you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
Photographs come down with us so you can see the condition without getting on a ladder.
Old sealant goes hard and cracks. We cut it out and redo it rather than laying new sealant over the failed stuff.
Usually the fix is new oversized fasteners with fresh washers through the whole field, at a fraction of what a replacement runs.
Scrap and old fasteners go with us, and the drive gets a magnet run over it.
Questions homeowners ask us about this kind of work.
No. Estimates for metal roof repair in Pollocksville are always free. Somebody comes out, gets on the roof, and leaves you a written price with nothing attached to it.
Always. On every Pollocksville job we cover the beds, haul debris away as we go, and run a magnet over the driveway before we leave. The metal roof repair is not finished until the yard is clean.
It depends on the size and pitch of the roof and on what we find once we are up there, so we will not throw a number at you over the phone. We measure your Pollocksville roof and put a real price for the metal roof repair in writing, free of charge.
Metal is our specialty, so metal roof repair on a standing seam or panel roof in Pollocksville is familiar ground for us. We work on shingle, slate and low slope roofs just the same.
Our reputation is just the roofs behind us.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Metal roof on the barn and one on the shed while they were already out here. Good work on both and the price was fair for that much steel."